i have bought an LG T300 and I am unable to remove the back cover. Can some body tell me how?
the cover does not come off, you must remove the entire light assembly and remove the bulb from the back side
Open tail gate, remove the two small screws going in from the side, wiggle tail light housing straight back and out.
Open the trunk and remove the nuts holding the assembly in place. With nuts removed the tail light assembly will come out the back then you can remove the light socket to replace the bulb.
The sliding door track cover is held on by two screws. To remove the sliding door track cover you must first open the door and look where the cover is located. You will see a screw, unscrew the cover at this location. The other screw is located behind the rear tail light cover/assembly. Remove the rear light by popping out two tabs/covers and unscrew light assembly. Once you remove the rear light you will see the other screw for the door cover. Remove screw. The track cover will now be able to be removed and replaced/repaired. Screw back in the same way.
Inside trunk, remove thumb screw to fold back paneling near tail lights. Then remove three thumbscrews and the whole tail light assembly can be moved out to change light bulbs.
the owners manuel will show you that in the trunk under the light there is two screws. you remove them and lift it from inside the back seat.
You have to remove the back black cover held on by 4 clips that look like luggage clips. Once you remove those you have to lift cover, that will give you acess to 3 nuts that relase back cover then you have access to bulb connections.
on the hatch back there is a cover on the door under the light remove it. there are three screws that hold the 3rd light on remove them. unhook the wire harness. remove the small screws from the 3rd light and pull it open. there you can unscrew the light and replace it.
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
When you open the back hatch on the vehicle you should see 2 rubber plugs on the edge of the tail light cover, use a flat head screwdriver to pry the both the rubber plugs all the way up. Surprise, they are what holds the cover in place! No screws or bolts! Replace the light bulb and put the cover back into place, push the plugs back down to secure the cover, and you're done.
Remove the carpet protecting the back of the taillight Pull away foam cover Losen screw and remove taillight When done you should be able to unclick the electrical wires Afterwards click-off the back cover of the taillight and you will stand with the base of the light in your hand. Gently push down and counter screw the bulb to remove it. Recommended buying good quality light bulbs to replace.
Try accessing the fog light from below. Remove under shield and see if you can remove the back cover. If you cannot remove the cover, then you may have to remove the fog lamp assembly. The bulb should be held in by a flip wire and is easily removable Hope this helps. BMW's are notorious for being difficult. Glenn