Want this question answered?
Use a screwdriver. Liscence plates are usually attached with screws.
with bolts or screws
Remove the covers from your 1988 Mercedes-Benz 300 speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.
M5-16 X 10mm
there are screws at the base of rod right next to the doors. remove them and your in business.
2 small screws under the filler
There are screws holding it on. Un-screw them.
To change the heater control panel on a Mercedes C180, remove the radio and the two screws under the CCU panel. Pry off panel and remove the bracket.
Remove 6 long hexnut screws from cover next to oilfill cap. Remove cover.
remove 4 screws on the front and 5 on the back. Just unscrew the ones that look like they are connected to the board
in the trunk, passenger side. small plastic type screws remove panel
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.