2 small screws under the filler
FYI I have an 84 vette and the front end is now worth a fortune as I never popped out the front plate section and left it original - there are under 300 left with original front end. Food for thought if you plan to keep the car long term.
For the rear plastic one, insert a thin blade screwdriver in the slots (two on each side of the frame about 1" from the top/bottom) and push back the tab while applying pressure to pull the frame away from the license plate. There are 4 snap tabs on the frame that just need to be pushed back to disengage from the body slots. Be careful, they're not very sturdy. The above answer is apparently for the rear, but I'll leave it there. The question was for the front, so... the front C5 license filler has a wide tab at the top that slips up into a slot in the front nose. It is held up there by two small Phillips head screws at the bottom of the filler. If you get on the ground and use a flashlight to look into the thin gap between the bottom of the filler plate and the bumper recess, you should be able to see a screw a couple of inches in toward the center from each lower corner. Use a small Phillips screwdriver to remove the 2 screws. Then you pull the filler plate out at the bottom just enough to clear the bumper and then pull it down to disengage the top tab. If you need a new filler, the current part number for a GM replacement (unpainted) is 10288540. They are around $110. If you do a Google Shopping search for that part number, you should be able to take a look at some pictures of one so you can see the wide tab and 2 screw holes. There are usually some on E-bay. Or, here's a picture I put in my album. Copy the link into your browser's address window and hit "enter": http://i59.photobucket.com/albums/g302/porxter/corvettelicensefillerplates001.jpg
On a UK car it is behind the driver's side front body panel. I had to partly remove the front bumper and the panel to replace it.
how do i remove a door panel on my C5 my interior door opener is broken
C5 and C6 are cervical vertebrae found in the neck. Anterior osteophytes of C5 and C6 are bone spurs that have formed on the front portion of vertebrae 5 and 6 in your neck. This can be a very painful condition.
To remove the handbrake cable from the front caliper of a Citroën C5, first, ensure the vehicle is securely lifted and supported. Locate the retaining clip or bolt that secures the handbrake cable to the caliper and remove it using the appropriate tool. Once the securing mechanism is removed, gently pull the handbrake cable out of its housing on the caliper. Make sure to check for any damage or wear on the cable before reinstallation or replacement.
Remove the fuse.
== ==
With a knife. A sharp one.
To top up the engine oil in a Citroën C5, first ensure the engine is off and cool. Locate the oil filler cap, usually marked with an oil can symbol, and remove it. Using a funnel, pour the appropriate type and amount of oil as specified in the owner's manual. After topping up, check the oil level with the dipstick to ensure it's within the recommended range before replacing the cap.
go to the mirror when u received video calls ;-)
In a Citroën C5, the headlights washer pump is typically located in the front of the vehicle, often mounted near the windshield washer reservoir. It may be necessary to remove some components or access the reservoir from underneath the vehicle for proper visibility. Always consult the vehicle's manual for specific instructions and diagrams for your model year.