Open the hood and remove the 1 screw holding the side marker. The marker, with a little presure, will push staight out forward.
All I did was remove the side marker lens by taking a small flat head screwdriver and pop it out. The side marker isn't screwed in so it comes right off. Then just remove the bulb by rotating counterclockwise.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
On my 2002 Nissan Xterra I had to remove 4 screws from the front bumper and wheel well and then I was able to get to the back side of the side marker light and remove the nut in order to get to the light bulb.
Remove the connector from the back of your 1997 VW Jetta side marker lamp. Take hold of the side marker lamp, push in and turn at the same time. The lamp will come out. Reverse the process to install the new side marker lamp.
Remove the connector from the back of your marker light assembly. The lightbulb can be removed by pushing it in and turning at the same time. Reverse the process to install your new side marker lightbulb.
I took a few screws out of the front wheel well mud guard behind the marker light and reached in through there to remove and replace the side marker light.
open the hood and there should be a black panel covering the access to the headlight assembly. remove this cover and you will see a 11 milimeter nut on a screw pointing directly to the center of the car (its attached to the side light) remove this nut. on the outside of the side marker light, there is a screw by the Lincoln emblem. remove this screw completely. now, pull the side leadlight assembly out a little and remove the socket holding the bulb to the side marker and snap the bulb out. simple procedure.
Its located on the back right side of the engine (passengers side) You will have to remove the black plastic intake pipe to really be able to get it easily, but that is where it is
On my 99 you remove the headlight assembly by removing the two plastic covered wing nuts, then remove the side marker/blinker assembly by removing the plastic covered wing bolt, then the light is accessible. It sounds harder than it is!
Front marker lights can be changed by removing front headlight assembly. To remove pull up on two metal clips behind light assembly and unplug wires. The side marker lights are now accessable. Turn bulb socket ccw to remove.
There's a Phillips screw at the top of the marker light. You would need to unscrew that and then you will be able to remove the side marker light from your Toyota 4Runner. We have also included a link to a video in the related links section below.