answersLogoWhite

0

If it anything Like a 1997 silverado extended cab there is one Phillips head screw towards the front of the console(you should be able to see where one would be, take it out, oddly enough it just has one if its like the extended cabs, the rear of the console there are 2 tabs and you should be able to slide the console forward, there is a orange and black wire that have a connection its pretty stubborn but that should be all the holds it, these instructions are for extended cabs

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Does the body control module control the information center on a 1996 Chrysler town and country?

It does send some info to the overhead console.


Just bought a jeep Cherokee 1996 limited what is that little black dome in the overhead console?

That sounds like your keyless remote sensor.


How do you remove a factory tape deck from an Acura Integra 1996?

The factory tape deck on a 1996 Acura Integra can be taken off by removing the center console. Once the console is off remove the remaining mounting screws on the radio and pull it out.


How do you replace the distributor cap on a 1996 Chevy Astro van?

Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.


Console - removal and installation for a Corsica 1996?

To remove the console from a 1996 Chevy Corsica, start by disconnecting the negative battery cable for safety. Then, carefully pry off any trim pieces surrounding the console, if applicable, and remove any screws that secure the console to the dashboard and floor. Gently pull the console upward and out, taking care not to damage any wiring or clips. For installation, reverse the process, ensuring all connections are secure and the console is properly aligned.


Where is the obd2 port on a 1996 accord?

It is under the ash tray in the center console. Just remove the tray and you will see it..............


Where is the starter located on a 1996 GMC Yukon?

the starter GMC Yukon?


How do you remove center console on 1996 Volvo 960?

Open the box in consol in the bottom remove a little plate with screw driver and you will see the 2 screws


What actors and actresses appeared in Yukon Gold - 1996?

The cast of Yukon Gold - 1996 includes: Vic Istchenko as Narrator


What transmission is in the 1996 Yukon?

That would be the 4L60E


How do you change the map light bulbs 1996 jeep grand Cherokee larado?

You are in luck, I just finished doing that this afternoon. You must remove the entire upper console. Theere is one screw in the from, right above the rear mirror assembly. Once you remove that, simply slide the entire console forward until it releases. There will be one red electrical connection that will need to be disconnected. Turn the console over and remove the map light assembly, remove lense and change bulb.


Why is your clock not illuminated on rover 416?

If you car is a 1990 - 1996 (3 box saloon) you prise the wood trim from the facia with a wide blunt screwdriver and replace the bulb by turning it a quarter turn. For later cars that look like a Honda Civic, chances are it may be a bulb or more likely the clock itself has failed (common fault) To gain access to the clock on post 1996 models.... Remove the rear console - posi screws on the sides at the rear (slide seats forward to gain access) Prise the cap under the handbrake to reveal 2 10mm bolts - remove Lift the console and detatch the e/window wiring plugs Remove console Prise out the HRW & hazard switches and unplug In the holes remove the screws with a magnetic screwdriver Remove the radio Remove the single screw in the radio aperture Remove the 2 screws either side of the centre console Remove the gear knob Gently remove the centre console to gain access to the clock & wiring Best of luck - its fiddly!