If it anything Like a 1997 silverado extended cab there is one Phillips head screw towards the front of the console(you should be able to see where one would be, take it out, oddly enough it just has one if its like the extended cabs, the rear of the console there are 2 tabs and you should be able to slide the console forward, there is a orange and black wire that have a connection its pretty stubborn but that should be all the holds it, these instructions are for extended cabs
It does send some info to the overhead console.
That sounds like your keyless remote sensor.
The factory tape deck on a 1996 Acura Integra can be taken off by removing the center console. Once the console is off remove the remaining mounting screws on the radio and pull it out.
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.
To remove the console from a 1996 Chevy Corsica, start by disconnecting the negative battery cable for safety. Then, carefully pry off any trim pieces surrounding the console, if applicable, and remove any screws that secure the console to the dashboard and floor. Gently pull the console upward and out, taking care not to damage any wiring or clips. For installation, reverse the process, ensuring all connections are secure and the console is properly aligned.
It is under the ash tray in the center console. Just remove the tray and you will see it..............
the starter GMC Yukon?
Open the box in consol in the bottom remove a little plate with screw driver and you will see the 2 screws
The cast of Yukon Gold - 1996 includes: Vic Istchenko as Narrator
That would be the 4L60E
To remove the center console from a 1996 Chevrolet Impala, start by disconnecting the negative battery cable for safety. Next, remove any screws or bolts securing the console, typically found in the armrest area and along the base. Carefully lift the console upward to disconnect it from any clips and pull it out. Ensure to disconnect any electrical connectors for features like the cigarette lighter or cup holder if applicable.
You are in luck, I just finished doing that this afternoon. You must remove the entire upper console. Theere is one screw in the from, right above the rear mirror assembly. Once you remove that, simply slide the entire console forward until it releases. There will be one red electrical connection that will need to be disconnected. Turn the console over and remove the map light assembly, remove lense and change bulb.