Use thinner for that paint.
Most sword blades are metal, using a bit of oil on a pad of steel wool (DO NOT USE SOAP PADS) rubbed gently along the blade will not only remove paint it will remove rust as well. If the paint is on the handle or scabbard , removing paint will depend entirely on what the handle and/or scabbard are made of.
If it's true stainless steel and not a coating, then yes, you can paint a pool ladder with an oil based enamel paint.
no there metal
The best way to get paint to adhere to stainless steel is to use an etching epoxy primer specifically made for stainless applications. Latex paint and oil-based paint are most commonly used.
It depends on whether it is a water (latex) based paint or a oil based paint. If it is oil based paint it may not come out, but if it is a water (latex) based paint use 'Goof Off' or other latex paint removers with a wire brush. I have used 'Muriatic acid' on some concrete appications.
Scrape it with steel spatula, get residue with Goo Gone.
I would use a chemical stripper.
Most sword blades are metal, using a bit of oil on a pad of steel wool (DO NOT USE SOAP PADS) rubbed gently along the blade will not only remove paint it will remove rust as well. If the paint is on the handle or scabbard , removing paint will depend entirely on what the handle and/or scabbard are made of.
no
please told the procedure of making the paint whether it is a steel paint or wall paint???????
If it's true stainless steel and not a coating, then yes, you can paint a pool ladder with an oil based enamel paint.
paint it
Yes you can. Use the appropriate paint or it will chip off.
It is possible to apply paint to galvanized steel. It must first be primed with a special primer. You must use a paint designed for this purpose.
The product is called "Oops". Read the instructions but it will clean paint off of almost any surface with no other damage. (Oops only works well for latex paints)
ultra fine steel wool for the glass. wax or rubbing compound for the paint ( carefull here test first with compound) I would use 3m finesse.
Bare steel + moisture + oxygen = rust. Paint provides a barrier to shield the steel from moisture and oxygen.