answersLogoWhite

0

You will see little round plastic buttom style head push ins.You take a small pin like an ice pick or awl and push lightly in,just a 1/8" and you will hear a click.It will come out by pulling on the head of the unit then.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Replace rear bulb Toyota 4Runner?

To replace the rear bulb in a Toyota 4Runner remove the plastic covers located in the trunk. Taking off the plastic covers will reveal the taillight housing and bulbs. Replace the bulbs.


Where is transmission control module 2002 Chrysler voyager ec 2.4 engine?

Inside the left front fender, remove the inner plastic fender liner to access.Inside the left front fender, remove the inner plastic fender liner to access.


How do you remove the plastic seat bolt covers on a Toyota supra?

To remove the plastic seat bolt covers on a Toyota Supra, gently pry them off using a flat-head screwdriver or a trim removal tool. Be careful not to damage the surrounding material. Once the covers are loose, you can pull them off by hand. Afterward, you'll have access to the bolts securing the seat.


Where is the windshield washer pump on a 1992 Toyota Tercel located?

it is in the drivers side fender under the reserve tank just take off your wheel and remove the plastic fender cover and you will be able to see it


Where is the battery on a 2000 Chrysler Sebring convertible?

It is under the left front fender, remove the plastic liner in front of the tire to access.It is under the left front fender, remove the plastic liner in front of the tire to access.


How do you remove a 97 Honda civic fender?

Support the car on jack stands and remove the wheel (loosen the lug nuts before jacking up the car). Remove all of the fasteners for the plastic fender lining and remove the lining. After this the fender just unbolts. There are a few bolts at the top (under the edge of the hood), a few between the door and fender (open the door to get to them), at least one holding the corner of the bumper to the fender (maybe just a screw), and one bolting the fender to a plastic "arm" coming from the headlamp.


2008 Toyota Tundra secondary injection air pump?

it's in the right fender well. remove inner fender and you'll see it.


Where is the horn on a 2006 HHR?

Behind the driver's side headlight. You must remove the plastic fender well to access it. Be careful not to break the plastic plugs holding some of the fender well.


How do you remove Toyota 1989 mr2 front fender?

To remove the front fender of a 1989 Toyota MR2, start by disconnecting the battery for safety. Next, remove any screws and bolts securing the fender, which are typically located under the hood, along the edge of the fender, and inside the wheel well. Carefully pull the fender away from the body, taking care not to damage any attached components or the paint. Finally, ensure all clips and connections are detached before fully removing the fender.


How do you take off right front fender on 1997 Maxima?

* Open the hood,raise the car and support it securely on jackstands and remove the front wheel.Disconnect the negative battery cable * Remove the cornering lamp from the fender * Pry out the plastic rivets,remove the screws and remove the inner fenderwell liner * Remove the fender mounting bolts * Detach the fender


How do you replace the windshield washer reservoir on a Toyota Corolla?

Remove the wheel on the same side is the water tank, then undo the plastic and metal fasteners that holds the plastic guard under the fender, then the tank is held inplace with two or three screws, and the wires to the pump


How do you change the antenna on a 94 Toyota pickup?

REMOVE THE PASENGER FENDER AND IT IS OBVIOUS... NOTHING TECHINCAL.