0
This is to complicated to write down so sorry but Good Luck !!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Will a 1990 Nissan automatic transmission fit a 1985 maxima?
no
Can I swap a 1985 Nissan 300zx automatic trans with 1985 Maxima trans?
I'm pretty sure the 85 maxima was front wheel drive?
How much would it cost to repair the transmission on a 1985 Nissan Maxima?
around 500$-------------------by hdlim
How do you remove the door lock on a 1985 Nissan 200SX?
what you should do is bring it to your local Nissan dealer and have them remove it
Will a power window motor from a 94 Nissan Altima fit in an 86 300ZX?
1985 - 1988 Nissan Maxima is the only other Nissan model with power window motors that will fit a 1986 300ZX.
How do you remove the front door panel for a 2001 Nissan sentra?
How do you remove and install front door panel 1985 Nissan Sunny
Where is the turn signal relay on a 1985 Nissan Maxima station wagon?
Look under the dash near the brake petal and steering colum.
What is the correct timing for a 1985 Nissan Maxima?
Ignition Timing degree B.T.D.C at idle speed 20 degree plus or minus 2 degree
How do I Remove the alternator on a 1985 300zx turbo?
Remove the belt from your 1985 Nissan 300 alternator. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. The alternator will come off.
How do you fix the radio on a 1985 Nissan Maxima that the volume is real loud then real quiet over and over?
I have a 1985 Nissan maxima....fully loaded. automatic, power everything. the stereo is equipped with an automatic volume control sensor that can be disabled (there is a knob or button on the stereo), but it automatically adjusts the volume of the stereo/radio when it detects noise from wind, ground, etc. This is a normal feature of the car. Hope this helps.
What else will a 1985 Nissan king cab canopy fit?
My 1985 Nissan king cab ;)
What would cause rack and pinion bellows on a 1985 celebrity to leak after replaced?
Sounds like you have a bad seal on the rack and pinion. The bellows is only to keep dirt and water out of the rack and pinion, it is not a seal to hold pressure in.
