Remove wheel, Remove drum or disc brake rotor,remove rear differental cover. Remove shaft between the spider gears that is held in by a lock bolt. Shove the axle from the outside toward the differential and remove the "C" clips that hold the axle in inside the diff. and then the axle can be removed.
Remove the tire and wheel from your 2003 GMC 2500 Sierra. Remove the end of the axle. Using a seal puller remove the axle seal. Reverse the process to install your new rear axle seal.
yes
It is located under the vehicle between the rear bumper and the rear axle you will need your jack handle to winch it down
how to remove rear axle from 1988 f250 ford
The 2003 GMC Yukon has 65.1 in. of rear shoulder room.
The 2003 GMC Yukon has 39.4 in. of rear head room.
The 2003 GMC Yukon has 61.3 in. of rear hip room.
were is the rear door relay located 0n 2003 yukon
The rear track of the 2003 GMC Yukon is 5 ft. 6 in. (66 in.).
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
The 2003 GMC Yukon-XL has 65.1 in. of rear shoulder room.
The 2003 GMC Yukon-XL has 39 in. of rear head room.
The 2003 GMC Yukon-XL has 39.1 in. of rear leg room.
The 2003 GMC Yukon-XL has 61.3 in. of rear hip room.
The rear track of the 2003 GMC Yukon-XL is 5 ft. 6 in. (66 in.).
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
how to get rear brake pads off 2003 Yukon denail
The 2003 GMC Yukon has rear wheel drive.
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
were is the rear door relay switch located on a 2003 yukon
No, you remove the 4 nuts on the outside, and pull the axle shaft out with a slide hammer.
synthetic gear oil
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.
The best way to remove the rear axle on a Polaris Hawkeye is to spray it with PB blaster. After waiting several hours or a day, simply pull the axle outward.Ê
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.