I have a 1993 318i 4-door. Rear seat removal is extremely easy.
The seat is held in place by 2 clamps in the seat which fit over corresponding fittings on the chassis. These clamps are positioned beneath the two main seating positions. To remove the seat, simply pull up on the front of the rear seat at each seating position which will easily disengage the clamps. Lift the front up about 30 cm. Pull the whole seat bottom forward which will disengage the rear of the seat from the seat back. Remove from car. Installation is reverse of removal.
best way to pull an engine 318 bmw
Just pull it out. No screws or anything
To remove the rear seat on my 91 535i you have grab under the seat about half way and then pull straight up. Hope this helps you out
Under the right back seat.
You will find there are two pumps. One is the prepump,. rear seat, behind passenger. Or LHS of vehicle. And the main pump is behind the driver. Or the RHS. This was on a 1993 BMW E65
Remove the rear seat.
If you pull up and remove the rear seat bottom the fuel pump is located on the passenger side right where they would sit in the back seat.
under rear seat
The battery is under the passenger rear seat, you can jump start it under the hood and you can disconnect it just below the rear passenger seat. If you want access to the battery, you must remove the rear passenger seat. if its not under the hood check under the back seat or in the trunk drive safe
don't steal.
How to open rear seat for batty on1989 BMW 735i
under rear seat