0
How do you remove replace igniton switch on a 1972 Chevy pickup?
Wiki User
∙ 11y ago
3) BEFORE your disconnect the terminals from the rear of the switch make note which one goes to which terminal (there should be four to five)Then replace the switch and replug the terminals in the order they came off (hence the note to mark which is which) one thing I didn't do, so now I am looking for the schematic and not having any luck - NOTE to self - ALWAYS make note of wires before unplugging. Good Luck it's pretty easy IF you remember to mark your wires.
Special Note: IF YOU DO NOT put the cyclinders back on in order the way you removed them, the key lock will not fit in back into the dash cylinder - Trust me, I did this - and then you have either a dangling switch or you have to use the pin again and start over. Good Luck LBB90210
Good answer! It worked just like you described. Too bad about your wires ... Maybe this will help:Purple to SolPink to IgnRed to BattBrown to AccLgt Brown to G1
If you need to know what connection they go to on the switch, then I can tell you what each blade is or maybe post a picture of it.
Good Luck
Read more: Discuss:How_do_you_remove_replace_igniton_switch_on_a_1972_Chevy_pickup
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you remove and replace ignition switch 1983 Dodge D150 pickup?
You have to remove it gently and go to auto zone and turn it in
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
How do you remove or replace the plastic knob on a 5 way guitar pickup switch?
Brute force. Just pull it off.
When you hold the key over to start position your truck will runif you don't it won't?
You need to replace the igniton switch
How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
How do you replace the ignition switch in 1996 S10 Chevy pickup?
Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.
How do you remove and replace the parking switch on a 1997 Chevy S-10 Pickup?
Parking switch? Do you mean the parking light switch? If you do, The dash will pull loose on the left top and bottom just above the switch and below. From there you can see how the light switch comes out.
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do you remove and replace wiper switch on 2002 Chevy Cavalier?
How do you remove and replace wiper switch on 2002 Chevy Cavalier
How do you replace the ignition switch on a 1997 Ford F150 pickup?
First of all disconnect the battery remove steering wheel , there is a round slot in the steering column you insert a rod in there it will release the switch ( be sure to remove negative cable or air bag can go off. You may have to twist the switch back and forth to remove
How do you replace an ignition switch in a 1992 cavalier?
First remove the steering wheel, remove the torx screws and remove the house, remove the signal switch and the wiper switch, remove the torx screws and?æremove the ignition switch. Put in the new switch and replace everything in reverse.?æ
How do you get to the ignition switch to replace it on a 1994 Chevy pickup?
Lower the steering column.
