Remove the 10mm bolt from behing the rear seat. Then pull the rear seat it hooks to the front seat in the front. Remove the bracket there and pull the front.
Yes, you just need to remove the center bracket (back seat bracket) on your bike
On most models, remove the screw that holds the rear seat bracket to the rear fender. Then slide the seat back so the front mounting bracket slides out of the frame. On many softtail models, there is a bolt on each side of the seat that attaches the driver seat to the frame. These must be removed before the seat can be slid back and off the motorcycle.
the folding tray OS bolted to the passenger seat. the passenger seat must be removed in order to unbolt the tray from the seat.Do not remove the passenger seat. remove the cover that attached to metal bracket of p. seat. it's mounted with two plastic screws. use flat screw driver to remove. then you will see 3 bolts on the bracket attached to p. seat. remove bolts and pull away.
remove mounting screw from top of rear fender then remove the two mounting fasteners located on both sides of the seat. loosen strap bracket by grasping and pressing down on the seat. pull out to free left side of strap bracket . push seat to the rear to free the tongue in the front. on some bikes you now have to unsnap the seat strap under the seat then slide seat through seat strap.
there should be a 10mm bolt that holds a bracket that holds the front seat down. under the pass seat. It is located in the center of the bike.
just pull up on it from the front of the seat it will pop out of the holders then un bolt the back of the bracket
the battery is located underneath the rear seat ,remove rear seat by pulling upward on front of rear seat remove from car.next remove both + and- cables then completely remove bracket that holds battery.remove battery,andsame directions in reverse order
Underneath on the drivers side even with where the back of the front seat is. It is on a bracket on the frame. To remove, open the gas cap, remove clips and flare fittings. The new filter comes with the bracket.
Push down on the seat while you are pulling the lever, then pull up on the seat. Edit: My 96 Kawasaki Vulcan has no leaver. You simply remove the thumb screw at the very back of the seat under the rack, then pull the seat backward till it pops free from the bracket.
You can remove the off a Suzuki 230 4 wheeler by locating the mounting bracket on the floor of the vehicle. Once you find that, you can remove the screws in the plate with a Phillips head screw driver, and take the seat out.
remove seat. remove two bolts holding bracket on left side of battery tray remove top bolt visible after seat is removed in step 1 disconnect battery leads remove battery