Want this question answered?
The 2006 Honda CBF 250 seat is held in place by four retaining bolts. Remove the retaining bolts to remove the seat.
On an '89, remove both side covers and you will see a bolt on both sides of the bike just under the seat. Remove the bolts, lift the back of the seat and slide toward the rear of the bike.
You have to remove the 28 mm bolts at the rear of the passenger seat on either side of the tail light. Now slide the passenger seat back to release a clip holding the front edge of the passenger seat. Then remove the 12 mm bolts holding the seat to the frame.
put your key into the helmet holder and unlock it then pull down on the latch attached to the helmet holder and lift the seat up
If you remove your seat, then remove your gas tank and radiator shrouds, then theres a black rubber coil going into the front/top of the motor remove that. then bam spark plug
how do you know if your fuel pump not working 1983 ford 250 an how do you change it
if it is the same as for a 1982 xt 250, you should first remove the seat and the gas tank, then only you have access to the engine.
250
250 grammaa - radioaktiivinen testamentti - 1983 is rated/received certificates of: Finland:K-8
find the fuse for the alarm if the fuse sevices alarm only remove the fuse other than that basically you are stuck with the alarm
If you're asking where the battery is on the bike. On my CBR 250 Hurricane it's under the seat, but you have to take off all the back seat and side panels to get the seat off which is a pain.
Take off the seat