Bleach the shirt and then let it soak in hot water.Bleach the shirt and then let it soak in hot water.
my best advice is to not spray hairspray on any clothing. it attracts dirt and stains like a magnet.
Because perfume is a liquid and when you spray it,the liquid is absorbed into your skin or clothing and you feel a bit wet,for some time.
Only if ingested. The chemical properties that make wet paint dangerous don't go away just because it dried.
Cookie dough ice cream, orange spray paint, wet leather, yeast and peanut shells
yes it is possible to spray paint a styrofoam ball. before spray painting a styrofoam ball, you must take a wet papertowel and smoothen out the styrofoam ball with it.
Either a "one stage" enamel paint, which can run from $100-$200 a gallon or you can use a "3 stage polyurethane" which can run from $100-$2000 a gallon. 1 stage enamel paints require you to prime and then paint the car with 3 or 4 coats, with a good wet standing afterwards, personally, I use 1500 grit, and then you buff it. 3 stage paint is a little more difficult if you don't know what you are doing. Body work and primer are a must, then you spray your base coats, wet sand it with 1000 grit, spray your paint coats, wet sand with 1000 grit, then spray your clear coats, and wet sand with 1500+. 3-6 coats of each stage recommended.
It is generally safer to touch a surface with dry paint compared to wet paint. Wet paint can be messy and may transfer onto your skin or clothing, while dry paint is less likely to cause any issues. However, it is always best to avoid touching any paint unless necessary to prevent any potential hazards.
Translation for 'wet paint' in the free French dictionary. More French translations for: paint, to paint, wet, to wet.
Cookie dough ice cream, orange spray paint, wet leather, yeast and peanut shells
liquid, gas-charged, pressurized, wet, enamel paint, or lacquer
Water based paint is fairly easy to remove. If it is still wet, you can just simply wipe it off with a wet cloth. For paint which has dried, you can use mild soapy water and then rubbing alcohol.
The easiest way to dry a wet distributor cap is to remove it and spray with a water displacing compound such as wd-40 and similar products.