0
You'll have to go around it with a trim puller first. You should be able to find one for $10 - $15 at any auto parts store.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you remove a rear door panel from a 98 Chevy blazer?
The 1998 Chevrolet Blazer door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
Is the tailgate for a 1998 GMC Jimmy interchangeable with any year Chevy Blazer?
The basic piece is the same but there will be different trim pieces attached that you will need to remove.
How do you remove tail lights on 1998 blazer?
The screws that hold the tail light in place are accessible only after you raise the hatchback or lower the tailgate. the screws are usually TORX drive
1998 Chevy s10 blazer fuse block diagram?
I need diagram for 1998 chevy blazer fuse panel
How do you remove the interior tailgate panel on a 1998 Explorer?
1. Open the tailgate.2. Remove the two Phillips screws from the base of the tailgate handle.3. Remove the small plastic cover located on the panel, at the base of window, four inches from the center.4. Remove the Phillips screw attaching the metal tab to the tailgate.5. While facing into the vehicle, grasp the base of the handle, and pull down-and-away; the handle should pop out of the tab-slot.6. The panel is held onto the vehicle by a series of plastic retainer tabs. Start at the top and work your way around as follows:7. While sitting on the tailgate and reaching up to the outside edge of the panel, pry away the four tabs placed equidistant across the top.8. Again working from the outside edge, pry away the two side tabs located about a foot below the top of the window.9. Open the rear window.10. Slide the entire panel up-and-front. The remaining tabs will all slide up, freeing the panel from the tailgate.
How do you access the backup bulbs on a 1998 E320 wagon?
You have to remove the the tailgate trim to access the bulb.
How to fix a stuck rear door on a Pontiac Transport 1998?
I did this with my 1996 Lumina APV. If you have rear speakers, remove the speaker cover(s), remove the speaker and reach in and find the mechanism, turn it to open. May have to do simultaneously for both sides. Then remove the tailgate panel and repair.
How do you remove the CD player from a 1998 Chevy Blazer?
is it factory or an add on?
Where is the fuel relay for a 1998 Chevy blazer location?
either in the underhood fuse panel of in the back of the glove box fuse panel
Where do you find the Horn fuse for a 1998 Chevy Blazer?
Fuse panel. Read your owner's manual.
Why doesn't the rear wiper work in 1998 Ford windstar?
Occasionally the wiper motor will seize up and stop working. I just solved the rear wiper problem today. The door latches on the tailgate of the Windstar have sensors in them. If the sensors aren't working the circuitry thinks the tailgate is open and won't turn on the wipers. Whether you have to change the wiper motor or not you have to remove the panel on the inside. It is simple, unscrew the loop closure from the inside. Get something flat and thin, slide it under the edge of the panel, get your fingers inside and sharply pull down, the panel will pop off. You can see the wires running to the tailgate latches. Because the drivers side gets more road grim do this side first. Reach in and disconnect the connection clip unplugging the sensor. Close the tailgate and try the rear wiper. If it doesn't work, disconnect the passenger side and try the wiper again. When you go to reinstall the panel cover on the tailgate, remove all the little plastic plugs from the holes in the tailgate and put them in the slots on the panel. A pair of pliers helps remove them. Slide panel over manual door lock button and push up on panel and it will snap in place. You may have to give it a hammer with the palm of your hand. Hope this helps. Worked for me.
How do you remove the inside handle off a 1998 civic?
Remove the door panel
