0
What else can I help you with?
How do you replace the wheel bering on a 92 Acura Vigor?
The front bearings on an Acura Vigor are pressed on bearings, unless you have access to a press or know of a shop that can do this for you I wouldn't attempt this job.
How do you replace front and rear brake pads on 2000 3.2 TL acura?
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put the new brake pad in, replace the brake shoe/caliper, put the tire back on and lower the car.
How to take off the front bumper for a 1992 Acura Vigor?
To remove the front bumper from a 1992 Acura Vigor, start by disconnecting the battery for safety. Then, remove any screws or clips securing the bumper, typically found near the wheel wells and underneath the vehicle. Carefully pull the bumper away from the body, ensuring to detach any electrical connections for fog lights if equipped. Finally, lift the bumper off its mounting points to complete the removal.
How do you remove the front rotors on a 2007 Acura TL?
Hello, Removing the front rotors on an Acura TL is clockwork. Here is a quick how-to guide: 1. Raise and safely support the vehicle. 2. Remove the front wheels. 3. Remove the brake hose mounting bracket. 4. Remove the brake caliper bracket mounting bolts, and remove the caliper assembly from the knuckle. 5. Remove the rotor retaining screws. 6. Remove the brake rotor by pulling it straight off the wheel mounting studs or if seized in place, remove the stubborn brake rotor by threading in two 8 x 1.25mm bolts, two turns at a time until the brake rotor is released. Good luck with your brake job!
How do you remove the Acura Integra 94 front brake rotor?
You'll need to remove the wheel, the brake pads and the caliper. Once all of that is out of the way, there are rotor retaining screws that need to be removed, either on the studs, or on the axle itself.
What tool to remove a front brake pads on a 2007?
= What tool to remove a front brake pads on a 2007? =
Where is the starter located on a 1991 Acura vigor?
The 1991 Acura starter is located near the front of the engine, on the left-hand side. You will find the starter near the bottom of the engine.
Removal of front lug studs on a 94 Acura Integra?
Lug studs on a 1994 Acura Integra is pressed into the hub. To remove the lug studs safely raise and prop the car. Remove the wheel, brake components, and suspension parts from the hub. Press out the old studs.
How do you replace the thermostat located on a 1992 Acura Vigor?
Remove the top radiator hose from the thermostat housing, its the round thing up front of the motor that the hose leads to it from the radiator. Then remove the bolts holding on to the top part of the housing, replace and reset all parts removed.
How do you remove front brake drum on kawasaki mule 2500?
You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
Where is the diagnostic port for an Acura RL?
remove the front ashtray, it is underneath
How do you remove a 94 Acura Integra front rotor?
See http://www.ehow.com/how_4506404_replace-rotor-acura-integra.html
