You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
25 MPH
Often, the VIN numbers are located right under the seat on the vertical panel. If they are not there, you may find them when you fold the seat up. If not there, pop up the bed and look on any frame work to where it could be stamped. ::You will find the VIN on your Kawasaki utility vehicle stamped into the frame front cross member between the front wheels of the MULE 520 and 550, or on the right side frame tube just behind the radiator grill at the front of the MULE 2500, 2510, and 2520.:: :: The Mongst ::
2500
2500
2500
To remove the rear brake drum on a Kawasaki 2500 Mule, first, ensure the vehicle is on a level surface and securely supported. Remove the wheel by loosening the lug nuts and taking the wheel off. Next, locate the retaining screws or bolts securing the brake drum and remove them. Finally, gently pull the brake drum off the hub; if it's stuck, you may need to tap it lightly with a rubber mallet to loosen it.
How do you remove the rear brake rotor on a 2005 Dodge Ram 2500?
You will need to remove the tire and wheel from your 1995 Chevy Cheyenne. Remove the brake assembly. Tap on the rotor with a hammer or mallet. The brake rotor will slide off. Reverse the process to install the new brake rotor.
To change the front rotors on a 1999 4x4 Dodge Ram 2500, start by safely lifting the vehicle and removing the front wheels. Next, remove the caliper bolts to take off the brake caliper and support it without stressing the brake line. Then, remove the caliper bracket bolts and slide off the old rotor; replace it with the new rotor, reassemble the caliper and bracket, and finally, reattach the wheels. Be sure to pump the brake pedal before driving to ensure proper brake function.
youtube.com has detailed video on this....
The manual for the 2006 Dodge Ram 2500 states that the torque on the front brake calipers should be set at 250 foot pounds. A proper torquing tool should be used.
1500 or 2500???
No, the rotor will come off with out the hub. After the brake caliper is off the only thing holding the rotor is rust. Hit between the studs with a hammer and it will come off.
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
1500 or 2500?? 6 lug or 8 ?
NAPA says .748 is throw away thickness for a 2005 2500 15" wheel front rotor with Bosch caliper.
You gotta remove the bearing cover do the brakes and repack it with the recommended fluid/grease good luck to ya