You cannot remove what it does not have. Your Buick does not have a governor. Speed is controlled by the ECU.
what is the down side of the 1997 buick park avenue
Yes, with another 1997 Buick Park Avenue.
How do you uninstall a starter for a 1997 Buick Park Avenue
$28000 for a new buick
The cost to replace a head gasket in a 1997 Buick Park Avenue ranges from $20 to $180+. This varies based on brand, store and labor costs.
No timing belt but a timing chain
Can anyone tell me why my new battery goes dead in my 1997 Buick Ultra Park Ave?
how to replace AC compressor on a 97 Buick park Ave
there is no heat inside the car what is wrong ?
The 1989 Buick Park Avenue does not come with a remote keyless entry. The keyless remote entry was not available till 1997.
Type your answer here...where is my theremastat located
The 1997 Buick Park Avenue does not have a timing belt. It has a timing chain.
The 1997 Buick is equipped with four motor mounts. There will be to motor mounts on the rear of the engine and two motor mount on the front of the engine.
the cars are basically identical but the park avenue is better built with other wanted fetures most standered including leather seats buick park avenues throught 1997 thourgh 2005 the park avenue is about 12" longer than the lesabre i would u buy a park avenue any day over the leasbre both are great cars but for the money the buick park avenue is the way to go .
on my car its under back seat and under the hood
on the left side of intake manifold under MAP sensor.
The 1997-2005 Buick Park Avenue's and Park Avenue Ultra's all use the same bumper cover part number. So I think the bumpers themselves would be interchangeable.
Try left lower firewall by steering column
If you put it on your self. The pump cost about $40.00
Check the fuse under the back seat it may be as simple as that.
if you have that manual go to the fuse box section, see what fuse it is and pull it out.
They pull right out after removing the wheel, caliper, brakes, rotor, axle nut and possibly the tie rod nut or ball joint nut, to allow the spindle to swing out of the way.
It is not possible to remove the power steering pulley on a 1997 Buick Le Sabre without removing the power steering pump.
The engine speed governor is part of the computer programming and can not be removed.