Straight forward - only problem you may run into is the bolt that holds the the rotor. You will need an Allen Bit 7mm to remove the rotor.
Remove rear calipers and pull. That simple.
removing rear rotors 2005 x-type
To remove the rear seat on a 1998 Jaguar XJ8, first, locate the release clips or screws at the bottom of the seat cushion and remove them. Then, lift the front of the cushion up and pull it out from the rear brackets. For the seatback, look for any bolts or clips securing it to the body, typically found at the base or sides, and remove them. Finally, gently pull the seatback upwards to detach it from the mounting points.
how do you remove and replace rear bumper on an xtype jag
Front or rear rotors and 2 wheel or 4 wheel drive, it makes a difference.
Removing Front & Rear Rotors Well Guys... I remove my Front & Rear Rotors out of my 1998 Ford Expedition XLT. I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off... The way I removed the Front & Rear Rotors was ... 1. I put lots of PB Blaster in the back and the front of the rotors to be removed. 2. I put plenty of tension with the 3 Jaw Puller... 3. I hit the back of the rotor with the sledge hammer... And it came right off... Hope this helps someone out there...
Removing Front & Rear Rotors Well Guys... I remove my Front & Rear Rotors out of my 1998 Ford Expedition XLT. I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off... The way I removed the Front & Rear Rotors was ... 1. I put lots of PB Blaster in the back and the front of the rotors to be removed. 2. I put plenty of tension with the 3 Jaw Puller... 3. I hit the back of the rotor with the sledge hammer... And it came right off... Hope this helps...
Removing Front & Rear Rotors Well Guys... I remove my Front & Rear Rotors out of my 1998 Ford Expedition XLT. I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off... The way I removed the Front & Rear Rotors was ... 1. I put lots of PB Blaster in the back and the front of the rotors to be removed. 2. I put plenty of tension with the 3 Jaw Puller... 3. I hit the back of the rotor with the sledge hammer... And it came right off... Hope this helps someone out there...
How do you remove the interior panel containing the rear woofer in a 2002 jaguar xk8 coupe? thanks
You have not set and adjusted them correctly.
Remove the cotter pin/nut in center & they pull straight off.
there are factory rivets which have to be drilled out