Chevy Blazer
Chevy Trucks and SUVs
Chevy Vans

How do you remove the back rotors from a 2002 Chevy Blazer?

333435

Top Answer
User Avatar
Wiki User
2015-07-15 19:58:12
2015-07-15 19:58:12

First you loosen lug nuts, then jack up your blazer then pull off your tires then the rotor should slip right off, but be sure your e-brake is not on or brakes engaged in anyway.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you remove the dashboard of a 2002 Chevy blazer

User Avatar

An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.

User Avatar

how do you set the timing on a distriubtor for a 2002 Chevy blazer

User Avatar

Take wheel off, remove brakes/caliper, remove dust cap, remove cotter pin, remove nut/washers and its off

User Avatar

If you can't access the bulbs take the light assy off and turn the bulbs counterclockwise to remove them

User Avatar

It does not have a fuel cutoff switch, you have to remove the fuel pump relay to disable the fuel pump.

User Avatar

I would like to know if my 2002 chevy blazer with a stock 4.3 vortec pull 2000 lbs ?

User Avatar

You will need to remove the front tire and wheels from your 2002 Jeep liberty. Remove the brake pads and break assembly. Tap the rotors with a hammer or mallet. The rotors will come off. Reverse the process to install the new rotors.

User Avatar

The fuse or relay for power windows on a 2002 Chevy Blazer is located under the dash near the emergency brake. It can be readily replaced by pulling it out.

User Avatar

Either warped rotors or drums can cause pulsating. Apply the parking brake slowly while going about 15mph and see if t pulsates. If it does, it is the drums that need turning. If not, it is the rotors that need turning.

User Avatar

How do I remove the rear shocks on a 2002 chevy camaro convertible?

User Avatar

How do you remove and replace wiper switch on 2002 Chevy Cavalier

User Avatar

Lug nuts to remove wheels 3/4" socket, bolts to remove the calipers 18mm, then pull rotor off.

User Avatar

It is bolted into the valve body in the transmission. You will have to remove the transmission pan that is bolted to the bottom of the transmission to service the shift solenoids.

User Avatar

how to remove back brakes on a 2002 Chevy surban

User Avatar

I have a 2002 Blazer with the 4.3L engine and it gets 17 to 19 MPG, average.

User Avatar

when you put drive chevy blazer 2002 ls 4wd it turns off, what's the problem

User Avatar

If a windshield wipe arm is loose on a 2002 Chevrolet Blazer, it likely needs to be replaced. It probably has a broken connection.

User Avatar

I have a 2002 Blazer with the 4.3L engine and 3.73 differential gear ratio, it gives me 17 mpg on average.

User Avatar

Same way as the front. First remove the calipers, then remove the two cross-point screws that hold the caliper in place . finally, remove the rotors and replace.

User Avatar

the plastic piece around the stereo should pop off straight out after that their is 4 screws that can be removed


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.