Slide a heavy screwdriver under the leading edge of the seat and pry upwards and the seat will snap out of it's retainers. Feed the seat belts through the holes in the seat and remove. This will then expose 2 bolts at the base of the backrest which hold it in plce, remove these and the backrest comes out.
remove back up tire in back right behind seat
check 9 pin plug in the back of radio also check wires going to speakers
Remove the wiring harness from the back of your 1995 Chrysler LHS alternator. Remove the alternator belt. Remove the alternator retaining bolts. The alternator will come off and can be replaced with the new alternator.
It is on the front of the transmission case.
You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job
You have to remove the entire rear interior- arm rests, all the plastic, etc. It comes loose in one piece. This link has a step-by-step how-to-http://as.timsoft.com/spikey/quarterwindow.html
the water pump is locate in back of the motor bracket on the left side of the engine it take about 4 hours to remove it
It is screwed into the exhaust manifold on the back of the engine.
The fuel pump on the 88' leBaron is located in the gas tank. to remove the pump you need to remove the tank. but one common problemeb with this is the muffler is in the way so it might help to remove that secton firstIt is NOT required to remove Gas tank to change fuel pump.,,it is on the back of tank,,raise car on hoist and look at tank from rear..
there is a rubber plug on the top portion of the motor .remove the plug,fill and put plug back on
A line comes out of your trans,then runs into you radiator,then back to your transmission.
On, off, on, off, on and it should flash codes.
Push down and back on the front edge of seat, 1st on left side then on right side. Then pull entire seat section up and out.
passengerside under the back seat . Look on the outside of the body. Not in the passenger space compartment.
its at the back of the engine.. located under the dipstic/ filler tube to the right of the alternator
If its anything like my 88 lebaron convertible on the inside your going to have to take out the trim on the floor by the door and then take off the whole side panel in the back seat...a pain!
4 inch in the dash 6 inch in doors and back 4 inch in the dash 6 inch in doors and back
I believe I have an answer for this, or somewhat of and answer. I have a 1995 Chrysler LeBaron, and I have had it stall on me while it is running, or when stopped at a stop sign, then it not be able to start back up for a while, or sometimes it will start right up. I googled it one day, and what I stumbled across was that it supposedly is the fuel pump. The 1994 and 1995 LeBaron has a faulty issue with the fuel pump that causes the engine to stall, and a few of the warning lights to come on. I have had this happen to me about 4 or 5 times, and all in convienient locations. I found this question googling for more information on the topic. If I could site the page I read that at, I would. But if you google it, I am sure you will come across the same info I have. OR, try calling your Chrysler dealership. I have yet to do so, being as how ours just closed in town.
NO yes and it will ruin your steering rack.
Four cylinder, it is on the back of the engine under the exhaust manifold. Six cylinder it is on the front of the engine, below the exhaust manifold.
Unzip back. Remove upholstry rings on the two bottom metal rods then slide the rear one half way out to fold it up. Remove rings holding middle metal rod. Push headrest halfway down. Slide a screwdriver up the front of the headrest post to keep the release lever from closing while removing the headrest. It is located behind the front seat foam. I have a 93 Lebaron GTC Conv
No. you have to remove the tank.
On eBay there about $160 to $200 dependiing on if you need the rear window. You'll have to remove back seats to get at the complete convertible frame. The tops will come with instructions. Its a lot of work and very time consuming plan for a whole weekend.
You have to remove the upper intake manifold.