Push down and back on the front edge of seat, 1st on left side then on right side. Then pull entire seat section up and out.
You have to remove the upper intake manifold.
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
map sensor is located on the upper intake on the passenger side near the back.
Remove the wiring harness from the back of your 1995 Chrysler LHS alternator. Remove the alternator belt. Remove the alternator retaining bolts. The alternator will come off and can be replaced with the new alternator.
The alarm functions are handled by both the PCM, under the hood, and the BCM, back side of under dash fuse panel.
check map sensor located on the upper intake manifold passenger side near the back
The distributor is on the right side of the motor and it is bolted with two bolts front and back. This part is to be removed very slowly a little at a time on each side where it is bolted. you must remove the intake to remove the dist. completely.
Remove ground cable. Using a prying tool, gently pry outward and remove the trim bezel. Unfasten the mounting screws holding the radio. Pull outward and remove the wiring harness and antenna lead from back of radio, remove radio from car. In stall in reverse order.
4 Cylinder it is on the back of the block. 6 Cylinder it is next to the oil filter.
back wheels.
No. you have to remove the tank.
remove the 15 mm nut and rock back and forth