* On fixed seats remove the bolts at base of the seat back sidecushions and detach them.Remove the two bolts at the rear of the seat cushion and detach the cushion assembly.Remove the two bolts at the base and remove the seat back * On folding seats remove the two bolts at the front of the seat cushions and detach the cushion assembly.Fold the seat backs forward remove the bolts and lift the assembly out
Under the back seat cushions in the middle. the bottom
The fuel pump is located in the gas tank to get to it you got to remove the rear seat.
in the tank is true but it is under the back seat. When you remove the seat you will see a round panel on the floor. Remove the bolts and unplug the connections and gently pull it out. Make sure your battery is disconnected first.
On fixed seats remove the bolts at base of the seat back side cushions and detach them.Removethe two bolts at the rear of the seat cushion and detach the coushin assembly.Remove the two bolts at the base and remove the seat backs. On foldingseats remove the two bolts at the front of the seat cushions and detach the cushion assembly.Fold the seat backs forward,remove the bolts and lift the assembly out.
2000 sonata rear seat removal
you have to completely remove the seat belt case and replace the seat belt, you can go to a junk yard, and get one from a compatible car.
The fuel pressure regulator on a 2005 Hyundai Elantra is located on the fuel pump inside the fuel tank. To change it you must remove the back seat. Under the seat there is a axcess panel through the floorboard to the fuel pump. Un hook the fuel lines and wiring, remove the screws that hold the pump to the tank. Lift out the pump from the tank. The pressure regulator is on top of the pump.
To remove the 2002 Hyundai accent rear seats find the tabs that cover the bolts and unbolt them. After the bolts are out lift the seat to remove it from the car.
under rear seat .
Fasten your seatbelt.
Fuel pump is located inside the gas tank. Access panel is under the back seat
fold down back seat and remove three pushpins-remove the two sides of the back seat with 13mm socket,bolts are towards the bottom of the seat cushion. remove seat belt anchors in back dash with same socket.remove third brake light buy pushing towards backglass then pulling up and away. don't forget to unclip wiring. Three or four pins hold the back dashpad in place. go thru trunk and pop clips back thru hole then go to back seat and pull out the dash cover and speakers are exposed.