answersLogoWhite

0


Best Answer

Tell her there's a big sale at Nordstrom?

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the ballast unit from the body of a 1998 gmc envoy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the door panel of 1998 Toyota Tacoma?

Call an Auto body guy


How do you remove the door on a 1998 ford explorer?

disconnect wiring harness, mark hinges, remove bolts securing hinges to body.


Where is the air intake temperature sensor a 1998 peugeot 106?

it is located on the inlet manifold below throttle body you need to remove manifold and remove sensor from underside


Where is the shift solenoid on a 1998 Dodge Intrepid?

It is located inside the transmission, on top of the valve body. Remove trans oil pan, drop the valve body and the shift/control soleniod is on the body.


How do you get the thermostat out in a 1998 Monte Carlo?

you have to remove the throttle body and use 13mm rench to take the thermostat housing bolts off


Is it easier to drop the exhaust off a 1998 Chrysler Voyager or remove the air filter inlet manifold and throttle body to change the three rear spark plugs?

It is easier to remove the upper intake.


Why is a 03 gmc envoy stalling?

check the throttle body for carbon build up probably fuel related


Location of the body control module on a 2002 GMC envoy?

2 BCM's on most 2002 Envoys. 1 is under the hood. The other is in the rear trunk lid, you'll need a torx bit to remove the trim to get access. What accessories are having issues?


What are the release dates for Body of Work - 1998?

Body of Work - 1998 was released on: USA: 15 March 1998 (limited)


Where is the crankshaft position sensor located on a 1998 golf 1.4 16v engine?

at the back of the engine, below the throttle body, to replace, have to remove the intake manifold


How can 5 fluorescent lights be connected together?

Connect them in parallel. The black wire from the ballast to the black line wire. The white wire from the ballast to the line neutral. Connect the ground wire to the ground screw which is located in the body of the fixture. Grounding of the fixtures is essential.


Will a 1999 Ford Escort ZX2 Motor Fit a 1998 body?

Not unless the 1998 body is a ZX2.