0
What else can I help you with?
How do you change power steering pump on 2007 gmc acadia?
1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement . 2. Remove as much power steering fluid from the remote power steering fluid reservoir as possible. 3. Place drain pans under the vehicle as needed. 4. Remove the drive belt. Refer to Drive Belt Replacement . 5. Remove the steering gear heat shield. Refer to Steering Gear Heat Shield Replacement ( See: Steering Gear > Removal and Replacement) . 6. Remove the right side catalytic convertor. Refer to Catalytic Converter Replacement - Right Side . 7. Disconnect the power steering fluid reservoir outlet hose (1) from the power steering pump. 8. Disconnect the power steering gear inlet hose (1) from the power steering pump. 9. Remove the power steering pump bolts (2). 10. Remove the power steering pump (1) from the vehicle. 11. Transfer any parts as needed.
1997 Nissan altima power steering pump replacement?
Begin by removing the power steering pump belt. Remove the power steering pump hoses. Remove the power steering pump retaining bolts. Reverse the process to install your new power steering pump.
What is the difference between a power outlet and cigarette outlet?
Cigarette lighter outlet is special outlet that will hold and power a cigarette lighter. A power outlet is designed so a cigarette lighter won't work with it. They look the same and most 12 volt car accessories will work in either.
Do you remove the alternator in a 1998 windstar to remove and replace the power steering pressure hose only?
Refer to the instructions in the "Related Question" below regarding alternator replacement.
what is the power on an electric cigarette?
The name says it "electric" power.
Where is the emergency flasher located on a 2000 gmc sonoma?
Under the radio to the left of the cigarette lighter and auxiliary power outlets. you must remove the bottom cover.
What would cause the cigarette lighter not to work in a 1995 Camry?
Blown fuse or damaged wireThe power wire that attaches to the back of the cigarette lighter is a real weak point for Toyotas. It probably melted or broke off and will require the replacement of the cigarette lighter receptacle.I had this same problem, and found that the cause was a washer in the base of the lighter socket that was not conducting (it is attached by a bolt and a screw). I expect it provides some heat protection. I removed this washer, replaced the bolt, and the socket now works. I'm going to look for a replacement washer or a replacement socket, since I've not gotten any info on what the purpose of this washer is, or what protection (if any) it provides.
Why might the cigarette lighter cell phone charger socket remains on in a 1999 Pontiac Grand Am even after the car is turned off?
The cigarette lighter / pwer socket is a constant hot socket. In most cars you can use this power socket at all times. It is best to remove anything(except the cigarette lighter) from this socket when the car is off.
How do I perform a hunter fan capacitor replacement?
To perform a Hunter fan capacitor replacement, first turn off the power to the fan. Remove the fan blades and housing to access the capacitor. Disconnect the wires from the old capacitor and remove it. Install the new capacitor in its place and reconnect the wires. Reassemble the fan and turn the power back on to test the fan.
2003 Dodge Caravan power window motor replacement?
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
Where can a replacement rope be purchased for a power pool cover?
Where can I buy replacement for power pool cover
What are the steps involved in furnace thermostat replacement?
The steps involved in furnace thermostat replacement are: Turn off power to the furnace. Remove the old thermostat cover and disconnect the wires. Remove the old thermostat from the wall. Install the new thermostat base and connect the wires. Attach the new thermostat cover. Turn on power to the furnace and test the new thermostat.
