0
To remove the computer on a 1992 Buick Roadmaster, first disconnect the negative battery cable to prevent electrical shorts. Then, locate the engine control module (ECM), which is typically found behind the passenger side kick panel. Remove any screws or bolts securing the ECM, disconnect the wiring harness, and carefully pull the unit out. Be sure to handle it gently to avoid damaging any connectors.
What else can I help you with?
How do you replace the front speakers on a 1992 Buick road master?
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
1992 Buick road master after you put a new battery it crank but wont start what is the problem?
1992 buick road master after you put a new battery it crank but wont start what is the problem
How do you change distribitor 94 Buick road master 5.7?
Biusx2x2123
What octane of gas should you use for my 1992 buick road master?
87
How do you diagnose if water pump on a 92 Buick roadmaster needs replace?
How to install a waterpump on a 92 Buick road master
How many tons does a 92 Buick Road master weigh?
Around 2 tons
What is the top speed of a buick road master wagon with the 5.7 motor?
108 mph
Did the lt1 come standard in the 1993 buick road master?
it didnt 1994 was the first year
Were is the igniton switch to 94 buick road master in the dash?
RH Side Of Steering Column
Where is the location of the fuel pump on a 1994 Buick Road master Wagon?
Inside the fuel tank.
Did the lt1 come standard in the 1995 buick road master?
Yes. There were no engine options, the LT1 was the engine.
How much can you get for a 1992 Buick road master?
Depends on overall condition, options, mileage, bodystyle, etc...
