Want this question answered?
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.
24x crankshaft position sensor--remove drive belt, raise vehicle up in front ( car ramps etc. ) remove the crankshaft pulley, remove the bolt and sensor wiring harness retaining bracket. remove the 24x crank sensor mounting bolts, remove the sensor and withdraw the wiring harness. for 3.1 V6 the 2.2 has a 7x position sensor. good-day !
The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.
Only one
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
how do I remove a watwr pump on a 2005 chevy malibu
The main pulley on which the serpentine belt goes on in a 1997 Chevy Lumina LTZ is the crankshaft pulley. The crankshaft pulley plays a role in the wheels turning and powering the alternator and power steering pump.
use an impact and it will break the bolt lose. You will have to mod or buy a tool to torque it down to spec
You'll need to pull the passenger front wheel, remove the wheel well cover. This will expose the damper pulley on the crankshaft. Remove damper pulley, remove plastic engine cover. Look inside you will see the sensor. Be sure if you replace it to install the new one exactly the same as the old one was.
In order to replace a timing chain for a 2003 Chevy Cavalier, a person will need remove the oil pan, crankshaft pulley and hub, timing cover bolts, and timing cover. Then the timing cover gasket, timing cover and bolts, crankshaft pulley, and oil pan will need to be installed.
frozen pulley