0
To remove the cylinder head on an Astra 1.7 CDTI, disconnect the battery cable and remove the lower engine cover. Drain the cooling system and remove the oil filter. Remove the air filter hoses and disconnect the crank case breather hose from the valve cover.
Wiki User
∙ 9y ago
Wiki User
∙ 12y agoTake it t a garage
Add your answer:
Earn +20 pts
Cylinder head torque settings for vauxhall 1.6i?
Hi need the torque setting for a Vauxhall zaferia 1.6 head
How do you remove cylinder head from 1991 Mercedes Benz 190e 2.3?
how remove cylinder head
How do you change lifters on a 1995 jeep cherokee Laredo?
You have to remove the cylinder head(s) to access the lifters.You have to remove the cylinder head(s) to access the lifters.
Where is the thermostat located on a vauxhall vectra 1.9cdti?
On the cylinder head (gearbox end), under the vacuum pump.
Where is the pcv valve on a vauxhall astra mk4?
PCV= Positive Crankcase Ventilation.It will be in the cylinder head cover.
Do you have to remove the cylinder head to change the head gasket?
Yes.
What is the torque settings for vauxhall zafira cylinder head z16xe engine?
25nm then 3 x 60 degrees
Cylinder head tightening sequence for Vauxhall Vectra?
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
How do you change head gasket on 1.8 L VW Passat engine?
Remove the cylinder head from your VW engine. Remove the head gasket and clean the head gasket surface. Put the new head gasket on and return the cylinder head to its original position.
How do you remove a cylinder head?
Start with undressing the cylinder head inlet and exhaust manifolds get a container for bolts and any other small stuff undo all of the cylinder head studs and lift off the cylinder head.
How do you change the injector seals on a 1.7 cdti Vauxhall Meriva?
can you change the injector tubes and seals without removing the cylinder head on a 1.7 cdti Vauxhall combi and is it much of a job
Fix a Blown cylinder head gasket?
remove head and replace gasket :)
