1. On manual window models remove the window crank handle dislodge the clip 2. Remove the outside mirror cover 3. Detach the door handle trim piece and disconnect the door pull mounting screw. Unplug the electrical connector from the power window switch 4. Remove the retaining screws and detach the panel by carefully prying it away from the door
Remove the door panel
The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
The 1998 Chevrolet Blazer door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
There are 10 Phillips screws holding the door panel on. First you would need to remove those. Then you can remove the door panel from the door. On the backside of the door panel you would need to remove the plugs from the backside of the switches. Then you can remove the screws that hold the switch into place on the door panel.
remove the door panel screws and pull up on the door panel to correctly remove it. then remove the 3 bolts on the upper corner and unplug and replace
Usually located behind the driver's door panel. Remove inside door panel for access
On manual window regulator equipped models remove the window crank handle.A shop towel worked up between the handle and door panel will usually dislodge the clip but it can also be removed with a hooked tool # Remove the outside mirror # Detach the door handle trim piece and disconnect the linkage rod.Remove the door pull mounting screw.Unplug the electrical connector from the power window switch # Remove the retaining screws and detach the panel by carefully prying it away from the door
The 1998 Honda Civic drivers side door panel is held on by eight retaining clips. Pry outward on each retaining clip to remove the door panel.
Call an Auto body guy
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
I just removed the door panel for my 2009 Elantra. (Instructions for driver door) First, look in bezel of door handle. Release cover for screw and remove screw. Look a little below at the door grip handle (or spare change holder if you will) and there is a cover for that screw too and remove that one also. Remove the triangle plastic cover that covers the wire harness to the side mirrors. I opened the door all the way and put my hand on the panel towards the front of the car where the door hinge is at. In my car, I felt a little outward edge of the panel. I slowly pulled it back and the panel started to come off. Don't try to take the whole panel out at once; you may break the plastic fasteners. I've not tried the rest of the door panels, but it might be the same.