Want this question answered?
On a 2004 E250, the bulb is loacted behind a panel on the passenger side rear door. The steel panel is secured to the door via four screws.
renault master door panel removal
With a wrench!
how do i remove the passenger door inside panel?
The 2002 Chevrolet Astro Van passenger door panel is held in place with two retaining screws and eight retaining clips. Remove the retaining screws and pry outward on the retaining clips.
yes
The only way is to remove the inside door panel (not an easy job with the door closed). Once the panel is removed, you'll have access to the latch mechanism. You will be having to remove this panel to put a new door handle on anyway.
My 93 is behind passenger side kick panel.
If code isn't written in the owners manual then remove the drivers door panel and get the code on label of the door handle.
Remove the black plastic covering from the top corner of the door panel (the piece that covers the bolts that hold the mirror in place) by pulling it straight out. It is held in place by single clip that will give if you apply enough force. Remove the screw that is underneath that attaches the top of the door panel. Remove the screw at the bottom left corner of the door panel. Using a flat head screw driver, pry the plastic piece behind the door handle out. There is a small tab in this to insert the tip of the screw driver. Behind this piece are two screws. One holds the door handle in place, and the other attaches to the door panel. Remove the one holding the door panel. Remove the controls for the windows and door locks by inserting the screw driver in the slot on the unit (similar slot to the one by the door handle). Remove the screw underneath that attaches to the door panel. Working your way around the door panel, loosen all of the edges from the door frame. Lift the door panel straight up and out.
Depends on what is wrong with the handle. You will more than likely have to remove the door panel in order to find out what is wrong.
The 2000 Chevy Astro sliding door panel is held in place by two retaining screws and eight retaining clips. Remove the retaining screws and pry outward on the retaining clips.