The 2000 Chevy Astro sliding door panel is held in place by two retaining screws and eight retaining clips. Remove the retaining screws and pry outward on the retaining clips.
behind right kick panel
To remove the inside rear door panel on a 2000 Chevy Astro, start by removing any screws located around the panel, usually near the armrest and door handle. Next, carefully pry off the panel using a trim removal tool to disengage the clips holding it in place. Once the clips are released, lift the panel upward to detach it from the door. Finally, disconnect any wiring harnesses for power windows or locks before fully removing the panel.
Is it bolted or riveted . Drill out the rivets and use bolt on the new motor.
Remove the screws in the door panel.
The only way is to remove the inside door panel (not an easy job with the door closed). Once the panel is removed, you'll have access to the latch mechanism. You will be having to remove this panel to put a new door handle on anyway.
Remove the inside door panel of your Chevrolet Astro Van. Remove the wiring harness from the mirror. Remove the side mirror retaining bolts.
To change the heater blower motor in a 1999 Chevy Astro van, first disconnect the negative battery cable. Remove the passenger side kick panel and locate the blower motor, which is typically situated under the dashboard. Disconnect the electrical connector and remove the screws securing the blower motor. Replace it with the new motor, reattach the screws and connector, and reassemble the kick panel before reconnecting the battery.
== ==
Chevy Tahoe remove front and rear speaker
The fuse box in a 2001 Chevy Astro is located under the dashboard on the driver's side. Specifically, it can be found to the left of the steering column, near the brake pedal. You may need to remove a cover panel to access it. Additionally, there is another fuse box located under the hood, near the battery.
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.