Now, when putting the panel back you should hook the windos switches up, with the plug that you pulled, and roll the window down, and there is a tweeter(the small speaker that's sitting right above the rigth side where the door panel was) that whole plastic piece will pop right out.
the whole job is quick, fairly easy, and only uses a Phillips head screw driver.
with hand and tools...
Door panels on a 1986 Honda Civic are held on by several mounting screws. Loosen the screws and gently pull the dash out. Doing so will remove any plastic clips.
Removing the door panels on a 2000 Ford Ranger is easy. All you have to do is snap out the old panels by unscrewing the bolts and screwing in the new ones.
remove the inner door panel first
The 2000 Mercury Villager front door panels are held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
in the door opener there is a cover, remove it to access the 2 Philips screws, then unclip the cover of the door andle to access the 2 Philips screws. grab the panel by the botom then unclip it
take the door apart then put it back on that's what i did to my metallic blue 2000 Honda civic with yellow flames on the side
pop the switch panel off and then the door mount support with a socket
The 2000 Buick Century door panel is held in place with for retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
http://prodactor.blogspot.com/2005/09/removing-door-panel-from-toyota.html
I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.
look at the handles inside the car and their should be screws take em out and it should be easy after that. Or check the door on the out side near the floor boards