answersLogoWhite

0


Best Answer

Adjust the mirror so it is centered [left to right] but pointing upwards a bit to increase the space between the bottom of the mirror and the mirrow housing. Place fingers in space at bottom of mirror and pull towards back of car. There are a couple of snap-on fasteners that hold the bottom of the mirror in place. Pulling carefully on the bottom of the mirro will eventually separate these fastners. The top of the mirror is held in place by a small tab that sits in a groove with a piece of wire that runs across the tab. Bias the mirrow downwards to remove the tab from its grove.

Replace by first positioning the mirror's fasting base [attached to back of mirror] so that the tab is located in its groove behind the wire that hold it there. Then push on the base of the mirror to "snap" its fastners into place. You will have to "wiggle" the mirror a bit so that it is positioned perfectly such that the fastners will work properly.

Test that the mirror is positively fastned to the housing by moving it into various positions and lightly pulling on the mirror.

NOTE: It is not necessary to remove the mirrow housing from the car to replace the mirror. This procedure works on the passenger side mirrow as well.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the driver's side mirror from the mirror housing on a 1999 Mercedes Benz E320?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the drivers side mirror on a Chevy Cavalier?

Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.


How do you remove drivers side mirror?

remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror


How do you remove the inside mirror from a Mercedes?

pull it down hard pops out


How do you replace drivers side mirror on 1966 Chevrolet Impala?

To replace the drivers side mirror on a 1966 Impala, remove the screws with a Philips head screwdriver. Remove the mirror , there will 2 5/16" bolts retaining the baseplate.


How do you replace the drivers side mirror on a buick rendezvous?

In order to replace the drivers side mirror on a Buick Rendezvous, you will need to remove the door panel. You will have to disconnect the electrical connector and you will be able to remove the mirror and place the new one on.


Can the mirror and motor on the passanger side of a 1995 Mercedes C280 be replaced without removing the housing?

YES IT CAN BE DONE. MOVE THE MIRROR THE THE FAR MOST DOWN POSITION AND UNCLIP IT FROM THE BACK OF THE MIRROR AT THE TOP. (THERE SHOULD BE A SILVER SPRING TYPE CLIP). MOVE MIRROR UPWARDS WITH HAND AND REMOVE. REVERSE ORDER TO INSTALL.


Remove drivers side seat from 1987 Mercedes 560sl?

visit mbca.org plenty of help there on mercedes....


How do you remove the interior rear view mirror on a 1990 Mercedes 300E?

The first step to remove the interior rear view mirror on a 1990 Mercedes 300E is to heat up the adhesive with a heat gun. Twist back and forth as the adhesive melts and pull the mirror from the window.


How do you remove the side view mirror housing on a 1997 SL?

pull off plastic inside directly behind the mirror it just pulls off and you will expose the bolts to remove the mirror.


How do you remove passenger mirror savana?

Passenger mirror access is same as drivers side. Three screws accessible inside door panel to remove entire mirror assembly. To remove mirror within the mirror assembly it just pulls off - snap fit of mirror mount to drive.


How do you access the battery under drivers seat in Mercedes 508D?

Remove seat!


How do you remove side mirrors?

remove drivers inside door panel and there are 2 or 3 bolts that hold mirror on from the inside after you diconnect the wire harness if it is a power mirror