answersLogoWhite

0

Take the inside door panel off disconnect the wires for the window and door locks(if you have power windows and locks). Unbolt the door at the hinge and your good to go If you are swapping your door with a used door that has a good wire harness, when you unbolt the door at the hinge, pull the wire harness from the "a" pillar and disconnect the two plugs there. No need to disconnect each plug then re-run the harness through.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove the radio on 1998 Mitsubishi Montero Sport?

how do i remove radio from 98 montero sport for #


Where is the fuel filter located and how do you remove it on a 1998 Mitsubishi Montero Sport?

The fuel filter is located on the drivers


What fuse controls the heater on a 1998 Mitsubishi montero sport?

Should be 4 senors. 3 on driver and 1 on passanger


How do you change out a starter on a 98 Mitsubishi Montero sport?

How to change a starter on a 1998 montero sport


Where is the dashlight fuse on a 1998 Mitsubishi montero sport?

In the front


How do you replace a windshield wiper motor on a 1998 Mitsubishi mirage?

How to replace wiper motor on a 1998 montero sport mitsubishi


Where is the starter located on a Mitsubishi Montero 1998?

On a 1998 Mitsubishi Montero, the starter is typically located on the driver's side of the engine, near the bottom of the engine block. It is mounted to the transmission bell housing, making it accessible from underneath the vehicle. To reach it, you may need to remove the protective splash shield and potentially some other components for easier access. Always ensure the vehicle is securely lifted and supported before attempting any maintenance.


What kind of transmission fluid does a 1998 Mitsubishi montero?

DEXRON II but DEXRON III will also work.


How do you take off the belts on a 1998 Mitsubishi Montero Sport?

To remove the belts on a 1998 Mitsubishi Montero Sport, first, ensure the vehicle is turned off and the battery is disconnected for safety. Locate the tensioner pulley for the belt you want to remove and use a wrench to relieve tension by turning the tensioner counterclockwise. Once the tension is released, slide the belt off the pulleys. Repeat the process for any additional belts, taking note of their routing for reinstallation.


How do you change front rotors on 1998 Mitsubishi montero sport?

To change the front rotors on a 1998 Mitsubishi Montero Sport, first, lift the vehicle and remove the front wheels. Next, remove the caliper by unbolting it and carefully hanging it aside to avoid stress on the brake line. Then, remove the caliper bracket, if necessary, and slide the old rotor off the hub. Finally, install the new rotor, reattach the caliper and bracket, and ensure everything is tightened properly before putting the wheels back on and lowering the vehicle.


At what mileage do you change 1998 Mitsubishi Montero timing belt?

i think it's every 65,000 miles or so.


Where is low pressure port ac system in Mitsubishi montero sport 1998?

On the compressor itself. It has an L on the cap.