Remove the switch panel by prying upwards with a flat screw driver once the panel pops out the group of switches will have some screws usually 4 or 5 then pry around the locking tabs it should pop out allowing you to remove each individual switch.
See the link here to learn how to remove the window switch assembly (steps 1-3)... http://www.autoclinix.com/Mercury/Front%20Speakers2.htm
Remove the decorative cover to the window switch panel. Remove the window switch retaining screws. Remove the wiring harness from the back of the window switch. Reverse the process to install the new window switch.
how do you bypass electric window switch on 88 toyota pickup
Pop the door panel off. Remove screws including the one behind the window switch. Then, lift up on the panel. You will see where the window switch plugs in.
pop the clips that are holding the Electric window switch and pull the switch out replace it and place it back in with the clips. if you broke the clips you will have to replace them. they only cost 1.05 at Chevy shop....
Its not really a tough job. Once you have removed the panel, you will see what you have to do. Just be careful of all the wires.
Begin by removing the inside door panel. Remove the wiring harness from the electric window regulator. Remove the window regulator retaining screws.
To remove the drivers side window and regulator, you will need to remove the door panel from the door. Then you can unbolt the regulator and window to remove them.
Undo the torx screw in the 'pocket' and pull it out gently. Unplug the cable and remove it completely.
what is the average repair cost to fix an electric window switch motor 2003 jeep
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
bad window motor if electric or a bad switch.