you have to loose two bolts on the power sterring pump 1) is on the front just under the belt that will allow you to losen #2. 2)this bolt is on the right side of the pump close the bottom you will have to losen it quite a bit then push and tilt the pump it should slide over.
How does the belt for fan and water pump go on a 2000 Jeep Cherokee Sport 6 Cylinder?
buy a new belt
I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.
Jeep Cherokee's have 2 cooling system fans and one climate control fan. One cooling system fan is fan belt driven and the other one is electric and is turned on/off by the engine computer at about 215*. The A/C and heater fan is electric.
Isn't it on the fan shroud?
I found mine on a sticker near the fan shroud
It's on the radiator shroud or brace, on the right of the fan.
Under passenger head light,must remove, relay is visible
Probably not. What you will do is remove the fan first, and then the fan shroud. The reason for removing the shroud is so you have more room to work.
The fan shroud is held in place by 4 bolts. Remove those and the upper radiator hose and lift out.
The 1990 Jeep Cherokee electric fan relay switch is located on the firewall in the engine compartment. The fan relay switch will be on the passenger side of the firewall.
try this, not sure if it the same moedel but the motor is the asme,,hope it helps http://www.wjjeeps.com/serpentine.htm