In my wheelset (fulcrum redmetal 3) you need an 5mm Allen key and an 17mm wrench
it was untighten clockwise (not anti clockwise as usual)
The joint, near where the tendon is attached to the bone, acts as the fulcrum.
FULCRUM
It is when a lever turns in moving a body.
pivot point or fulcrum are the joints in the muscle.
The fulcrum is the point of the lever where a change in motion will occur. There are 3 types of levers that are illustrated at this URL (http://i1131.photobucket.com/albums/m554/skyop22/Answers%20Pictures/levers.gif). The three types will distribute the load differently based on where the fulcrum is.
Because a second class lever is a lever in which the resistance is located between the fulcrum and the effort. When you stand on your tiptoes, the fulcrum is located at your toes, the effort is at your Achilles tendon, and the resistance is the weight of your body pushing down. therefore, the resistance is between the fulcrum and the effort.
A rocking horse typically consists of a lever (the horse's body), a fulcrum (the rockers on the base), and possibly a wedge (for stability). The rocking motion is created by the lever and fulcrum working together.
You will need a puller to remove the steering wheel, after you remove the nut and snap ring in the center of steering wheel. Ther are two holes in the wheel that are threaded. Install puller on center shaft, and screew 2 long bolts through the puller and into the holes on wheel.
Human-powered bicycles haven't got flywheels.You're probably thinking about a freewheel. Only rather cheap MTBs have freewheels, as they're prone to axle breakage. Better ones have freehubs.To remove a freewheel you need a special tool called a freewheel puller, and they're available in at least 4 different types.To remove a (shimano) freehub body you need a cone wrench, a lock ring tool, a chain whip and a large Allen key.
# Lower the glove box and disconnect the antenna cable connection # Remove the antenna mast # Loosen the right front wheel lug nuts and support truck on jackstand # Remove the right wheel and inner fender splash shield # Remove the antenna bas mounting bolt and detach the grommet and cable from the body then lower the assembly from the wheel opening
the shoulder is the fulcrum and the load is the rest of the arm. the deltoid muscle is lifting the load away from the body from a point closer to the fulcrum, so it is a class 3 lever.
Remove left rear wheel plastic housing cover under the body you can then access the antenna motor.