== ==
== ==
== ==
how to remove front bumper on Toyota avensis 2003
First, you'll need to remove the front bumper. To do this, take off the bolts underneath the front part of the bumper. Remove the bumper turn signals to access the two bolts per side that hold the bumper on the car. Support the bumper by putting something underneath it. Then get a stubby Phillips screwdriver and remove the two screws per side at the end of the bumper (in the wheel well). Bumper should come off. Remove the headlight assembly by diconnecting the headlight sockets, remove the 10mm bolts above each headlight assembly. Remove the 10mm bolts below the headlight assembly. Done.
In the front bumper. Drivers side. You have to remove the underpan plastics to get to it.
how to remove front bumper 2002 Impala
how to remove front bumper on citroen berlingo
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
Remove front wheel. Remove splash apron. remove air deflector. Remove front bumper. Now you can access the headlamp assembly.Can you give me a diagram
nightmare. you have to remove the front bumper cover. then you will see the bolts holding the lamp assembly.10mm socket
In order to remove the headlight assembly, you must remove the bumper (which is easier than it sounds and will only take about ten minutes or less). This will also save you time and aggravasion. The reason the bumper must be removed is that there are two brackets underneath the headlight assembly that are very hard to get to without this step. To remove the bumper: 1) remove the two screws from each of the front parking lights, 2) remove the connectors to the parking light assemblies, 3) remove two screws in each wheel well (forward area), 4) remove two 10mm bolts underneath the middle, front of the bumper, 5) remove three large head screws from the top middle of the bumper (in front of the hood latch), 6) hold the bumper and remove the two 11mm bolts from behind the parking lights - the bumper will drop after the bolts are out. There are five 10mm bolts holding the assembly onto the car. To remove the headlight assembly. remove the top three 10mm bolts from the top black brackets. Remove the bolt from the outside bottom part of the headlight assembly and the bolt under the assembly. The two bolts on bottom are held in with brackets that can be loosened/adjusted to remove or install this assembly. To disconnect the side marker light assembly from the headlight assembly, loosen a screw (looks like an adjustment screw) and remove the lens. Two screws hold the two assemblies together.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.