1) Remove the Torx screws just in front of the front wheels attaching the front bumper to the plastic bodywork parts.
2) Flip off the outer front grills, that house the fog lamps if you have them.
3) Lie on the floor looking up, and you'll see an 6mm Allen headed Bolton the underside of the reveals.
4) Remove.
5) Carefully tug the bumper off, trying to keep it straight and square.
6) Carefully remove the electrical connections.
That's it
how to remove front electric head rests on audi a8
On the 1998 Audi A6, the turn signal bulb can be replaced by opening the hood. Reach into the turn signal from the fender wall and push in and turn the old bulb to remove it. Push in and turn to replace with a new bulb.
This is an extremely difficult fix. If you must know, you have to remove the front bumper and radiator. It is on the left side when you are facing the car.
To remove the front passenger-side motor mount on a 1998 Audi A4 Quattro, first ensure the vehicle is securely raised and supported. Disconnect any electrical connectors and remove the bolts securing the mount to the engine and the chassis. Use a jack to slightly lift the engine for better access if needed, and then carefully remove the mount. Finally, inspect the area for any debris or damage before installing the new mount.
http://wiki.answers.com/Q/How_do_you_change_the_front_axle_on_a_1998_Audi_A8"
First, remove your left front wheel. Then remove the left front fender liner by taking out the torx screws. Now you will see the funky shaped reservoir. It has three mount bolts: 2 behind fender liner, one under hood by the fill point. You will need to pull the two fluid pumps and the fluid level detector out of the reservoir. If it wasn't empty, it is now :). Installation is same in reverse.
The crank sensor on a 98 2.6 Audi A6 is in front of the driver's side wheel axle. The left front tire must be pulled out to reach it.?æ
Remove skid plate, it is to the left in front of the engine.
Audi Front was created in 1933.
you probably don't want to do it...you have to take off the front bumber just to get to it
http://a4mods.com/index.php?page=webcontent/pages/bumperremoval.html
go through the trunk