Mitsubishi Galant

How do you remove the front rotors from a 1996 Mitsubishi Galant?

202122

Top Answer
User Avatar
Wiki User
2014-09-18 00:22:13
2014-09-18 00:22:13

Anchor and lift the vehicle. Remove tires to expose rotors and enclosing. They can be hard to remove so use a tool with force, remove center bracket then gently hammer out of place. Exchange old rotors for new. Return mechanisms and tires.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I believe the awnser varies on what model you have... I have a 1999 galant GTZ mine has disc ( rotors ) front and back, The rear has the disc drum combo for the parking brake... Hope this helps

User Avatar

on 1999 Mitsubishi galant the transmission have stop working it don't go front or back what can I do to fix it.

User Avatar

how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd

User Avatar

First remove the right and left tires, and then proceed to remove the rotors. After you have replaced the rotors put them back on.

User Avatar

pull off the front wheels. remove the calipers. remove the two screws that hold on the rotors. replace the rotors and reverse the procedure.

User Avatar

on the front side of the throttle body.

User Avatar

2001 Mitsubishi galant ES. Speaker specs Front door: 6 1/2" Rear deck: 6 x 9"

User Avatar

the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.

User Avatar

With the wheel off, remove the calipers, then the rotors just come off.

User Avatar

under the front of the car on the driver side .

User Avatar

"http://wiki.answers.com/Q/How_do_you_change_front_rotors_on_1994_mitsubishi_3000gt"

User Avatar

how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up

User Avatar

The rear deck speakers in a 2002 Mitsubishi Galant measure 6 inches by 9 inches. The front door speakers measure 6 3/4 inches.

User Avatar

Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.

User Avatar

I drilled out the bolts that held it in place because they were thoroughly rusted in place. Once that was done the rotors came off easily.

User Avatar

Jack up and safely support front of vehicle. Remove front wheels. Remove front brake calipers and hang them with wire so not to damage brake hoses. Remove brake caliper brackets. Remove brake rotors. Rotors may need a little persuasion with a large hammer as they may be stuck/rusted in place. Reverse order to install rotors.

User Avatar

You will need to remove the front tire and wheels from your 2002 Jeep liberty. Remove the brake pads and break assembly. Tap the rotors with a hammer or mallet. The rotors will come off. Reverse the process to install the new rotors.

User Avatar

Jack the front end up of your 1994 Ford F2 50. Remove the tire and wheel. Remove the brake pads and assembly. Tap on the rotors until they are loose. The rotors will slide off. Reverse the process to install the new rotors.

User Avatar

remove the brake caliper and the rotors come right off

User Avatar

Remove brake caliper and caliper frame. Rotors are now free.

User Avatar

Recommended pressures 34 psi front, 31 psi rear.

User Avatar

Is behind the front board, right behind the stereo

User Avatar

You will need to remove the tire and wheel. You can remove the brake pad and break assembly, by removing the brake spring and caliper. Loosen the rotors with a hammer. The rotors will slide off. Reverse the process to install the new rotors.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.