Jack up and safely support car
Remove the following component's: Wheel, Brake caliper, brake rotor.
Disconnect tie rod from spindle
Support lower "A" arm with stand etc
Remove nuts for upper and lower ball joints.
Use an appropriate tool to release the ball joints from the spindle, do not use a fork and hammer as this will damage the joint, there are special tools available for this purpose.
Once the joints are released you should only have to heave to get the spindle out.
No the transmission does not have a governor.
Yes. The THM125C has a governor. The governor is just below the speedometer sensor. 1986 Pontiac fiero service manual section 125C page 22.
There are two horizontal bolts at the front of the cradle, and two verticle bolts at the rear. You do of course have to deal with the engine, transmission, brakes and suspension also.
Remove rr wheel and unbolt/swing strut out of the way. Crazy I know but that's the deal
The horns (2) are located at each side under the headlights in the front clip
The front hood raises from the rear or windshield end, the rear hood raises from the rear or bumper end
Left passenger side standing in the front of vehicle.
how do you replace side windows 85 fiero
Yes
== ==
== ==
NO