answersLogoWhite

0

remove all retaining clips and loosen transvecular joint be careful not to damage the wobbler shaft then gain access to the lower grille by the muffler bearing right beside the canooter valve

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you unlock a 2007 Chevy Cobalt?

With a 07 chevy cobalt key


What is the wrench size needed to remove oil pan plug on a Chevy 2007 Cobalt?

15mm


Where is the external temperature sensor located on 2007 Chevy Cobalt?

The external temperature sensor on a 2007 Chevy Cobalt is typically located in the front of the vehicle, near the grille or in the lower front fascia. It is often mounted behind the bumper or around the front radiator area, allowing it to accurately measure the ambient air temperature. To access it, you may need to remove the front bumper or lower cover.


How do you change the shift knob on a 2007 Chevy Cobalt?

Here's how to remove it. http://www.youtube.com/watch?v=hH2qZPIK7jQ


How do you remove the engine cover on a 2007 Chevy Cobalt 2.2L engine?

Remove oil filler tube cap....then Wiggle and pull straight up.


Where is the fuse box on a 2007 Chevy Cobalt ls?

Passenger side, underneath the glove box. You have to remove a panel from the center console.


Where is the battery located in a 2007 Chevy Cobalt?

in the trunk


Where is the kill switch in a 2007 Chevy Cobalt?

It does not have one.


How do you remove starter on 2007 Chevy Cobalt?

To remove the starter from a 2007 Chevy Cobalt, first, disconnect the negative battery cable to prevent any electrical short. Then, lift the vehicle and support it securely. Remove the starter's electrical connections, including the battery cable and the smaller wire, and then unbolt the starter from its mounting bracket. Finally, carefully pull the starter out of the engine compartment.


How do you remove front wheel hub assembly on 2007 Chevy Cobalt?

To remove the front wheel hub assembly on a 2007 Chevy Cobalt, first, lift the vehicle and remove the wheel. Then, disconnect the brake caliper and rotor to access the hub. Remove the axle nut, and unbolt the hub assembly from the steering knuckle, typically using a socket wrench. Finally, carefully pull the hub assembly out of the knuckle to complete the removal.


Will a 2007 Chevy cobalt SS supercharged engine fit the mounts in the Chevy cavalier?

No it will not


What the best gasolone for Chevy Cobalt 2007?

87 octane