take out the two screws on the turn signal lights, the metal strip above the lenses is on a spring hinge. Simply pull the lenses toward you and the metal strip will spring up. Put the new lense in the groove on the metal strip above lense and push back in. Put in your screws for the turn signal light and your all set. Good luck
Remove the head light cover plate, then remove head light braket, once you have done that pull the light out and un-plug it.
there should be a label on the back of the cover that you had to remove to get to the fuses.
changing a head light bulb in an odyssey is real easy. first remove connector from back of bulb. then remove rubber cover by pulling on one of the tabs. then remove retaining clip which holds bulb in place. remove old bulb, replace with new bulb, replace retaining clip, then replace rubber cover, and reconnect connector. all done. each light takes about 2- 5 minutes
There is a small slot on the hard plastic cover near the end of the dome light you will need a small flat head screw driver insert the screw driver in that slot use a back and forth motion to remove it.
It is in behind the dash right beside the head light switch. You will have to remove the plastic dash cover on the front of the dash to get to it.
Open the hood to your vehicle and locate the retaining clips, using a flat head screwdriver release the retaining clips. With that done you can remove the bumper light and disconnect the harness. With the headlight removed you can now remove the cover if you wish.
It is mounted in the dash to the right of the head light switch. You will have to remove the plastic cover on the front of the dash to see it. The cover/trim piece just snaps in place.
Remove the cylinder head from your VW engine. Remove the head gasket and clean the head gasket surface. Put the new head gasket on and return the cylinder head to its original position.
Just below the head light there is two round things. One is the horn and the other is the fuses. you will need a screwdriver to remove the cover.
Remove the valve cover and you will see it stamped into the top of the head.
HOW DO I CHANGE LIGHT BULBS
you have to remove the head-light assembly to get the turn signal bulb front and rear lights The side light has one screw on top to the outside of the headlight assembly holding the cover in place.