For the driver side headlight assembly(for passenger, reverse lefts and rights), there are 3 10mm bolts. One on the right top near the fender, as you're looking at the car. And 2 on the left side of the assembly, facing the engine, next to the radiator. Once the bolts are removed, pull the assembly straight out. This may take some force as the assembly is still being held in place by a plastic clip on the lower right of the assembly. Once removed, the low beam bulb is accessible by giving a slight turn to the round piece on the back of the headlamp assembly directly behind the low beam lens. There is a large O-ring holding it in, so give it a tug if it doesn't come freely. The metal bulb retaining clip can be released by pushing the side opposite of the screw, down and to the side. The retaining clip should hinge out of the way freeing the bulb. When installing make absolutely sure you fully seat the assembly back into the plastic clip before replacing the bolts. For me this took a sharp push, with my left hand on the top center, and my right hand on the bottom right of the assembly. And it still took me a few tries to get it to clip in. As long as you keep the pushing force to the outside of the plastic lens, and not the center, you shouldn't have to worry about breaking it.
Be sure to purchase your replacement lamps before disassembling. See sources and related links below for lamp number information.
Changing a 2007 headlight bulb is very easy. You will need to open the hood and find the bulb at the corner of the headlight assembly. Then you will turn the bulb socket counter clockwise to remove. After the bulb is out, you will replace it with a new one and screw it back into the headlight assembly.
My 2007 Kia Spectra stalls. The dealership is changing out my entire gas tank assembly.
Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector
Remove the wiring harness from the back of your 2007 Chevrolet Corvette headlight. Remove the headlight retaining bolts. The headlight will come out and can be replaced.
Remove front wheel. Remove splash apron. remove air deflector. Remove front bumper. Now you can access the headlamp assembly.Can you give me a diagram
Remove the wiring harness from the back of your 2007 Mercedes-Benz headlight. Remove the headlight retaining bolts. The headlight will come out. Reverse the process to install your new headlight.
The a/c fill point on a 2007 Focus is located on top of the condenser behind the passenger side headlight. Remove the headlight assembly and then you can access the low pressure port on top of the condenser, a silver colored cylinder.
You need to remove the bumper assy in order to access the Head lamp, also be sure to by all fender covers clips before you do that.
you will probably have to take the complete headlight assembly out to get enough room to change the bulb.
Hi I have a 2001 and there is a leave (small) in side behind the head light you push it up. That will unlock it then the light it tight but you can then pull it forward to remove it. Very simple once you unclock it.
Under the left headlight. You need to pull the headlamp assembly to access it
where is the flasher relay on a 2007 KIA SPECTRA