To replace a headlight on a 2008 Toyota Prius, first, open the hood and locate the headlight assembly. Disconnect the electrical connector from the back of the headlight bulb and remove the rubber dust cover. Twist the old bulb counterclockwise to remove it, then insert the new bulb by aligning it and twisting it clockwise. Reattach the dust cover and reconnect the electrical connector before closing the hood.
Should be under the hood, right hand side in the electrical enclosure with other switches and relays. Take the cover off and the diagram on the inside tells you which is which. In our 2000, the headlight relay is marked HEAD.
What do you mean by headlight cover?What are you trying to do?JW
It is just clipped in. Just pull up - it will snapp off.
To replace the valve cover gasket on a 1998 Toyota Sienna, first, ensure the engine is cool and disconnect the battery. Remove any components obstructing access to the valve cover, such as the air intake or ignition coils. Unscrew the valve cover bolts, carefully lift off the cover, and remove the old gasket. Clean the mating surfaces, place the new gasket in position, reassemble the cover, and torque the bolts to the specified settings before reconnecting the battery.
Headlight cover? The headlight can be removed by first removing the bumper cover. THen all the bolt that attach the headlight to the vehicle will be exposed. The "cover" is glued to the headlight housing.
Are you entirely sure there _is_ a headlight cover?
The air cabin filter in a 2000 Toyota Sienna is located behind the glove compartment. To access it, you typically need to remove the glove compartment by unhinging it and then locating the filter cover. Once the cover is removed, you can slide the filter out for replacement. Always refer to the vehicle's manual for specific instructions.
Open Hood. Remove the cover from the headlight by prying up the keeper. Remove the metric 13 nuts holding the headlight in. Take out headlight and replace the bulb. Reinstall the headlight and reinstall headlight and cover.
Sell it!
To remove the headlight cover on a 1994 Chrysler LHS, start by opening the hood and locating the screws or clips securing the headlight assembly. Remove these screws using a screwdriver or socket wrench. Once the screws are out, gently pull the headlight assembly forward to detach it from the vehicle. Finally, you can carefully remove the headlight cover from the assembly.
there are 3 5mm Allen nuts in the front. these are easy. the weird part is the back. there is a Toyota symbol in the back center. twist it counterclockwise till the shield is released.