Just remove the upper trim work around the doors and such... that's basically all that's holding the head liner up.
Dodge Spirit was created in 1989.
Yes. Just switch the headlight brackets out.(remove the headlight bracket from the CRX headlight/ install the CIVIC headlight bracket on the CRX headlight.
R-12
You have to remove all of th a/c ducts etc. It is a big job. Get a manual on your car if you want to tackle it.
Do not believe there were any Dodge Spirits made until 1989! Dodge Spirits was made from 1989-1995, that's when they was replaced by the Plymouth Breeze and the Dodge Stratus.
Begin by removing the wiring harness from the back of your 1989 Silverado headlight assembly. Remove the low beam headlight assembly retaining bolts. Reverse the process to install your new low beam headlight.
remove the screws holding the ring around the light then remove the light.
It is located under the vehicle, attached to the engine.
On your 1989 DODGE SPIRIT, the FILTER-FUEL is: UNDER VEHICLE, PASSENGER SIDE, BELOW TRUNK AREA, NEXT TO FUEL TANK, MOUNTED ON FRAME IN FUEL LINE You can find this stuff free at autozone.com under repair info, component location.
To replace the water pump on a 1989 Dodge Spirit Turbo, first, disconnect the negative battery cable and drain the coolant. Remove the drive belt, then take off the timing belt cover to access the water pump. Unbolt the water pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble everything in reverse order, refill the coolant, and check for leaks.
the metal is clipped on. pry it off with flat screwdriver and thre rest is self explanitory
To change the headlight on a 1989 Toyota SR5 truck, first, open the hood and locate the headlight assembly. Disconnect the electrical connector from the back of the headlight and remove the retaining clips or screws holding the assembly in place. Carefully pull out the old headlight bulb and replace it with a new one, ensuring it is securely seated. Reassemble the headlight assembly, reconnect the electrical connector, and test the new headlight to ensure it works properly.