You push the "knob" in, and turn it anticlockwise, the unit should pull out then.
To remove the headlight unit from Vauxhall Vectra SRI 1999, first remove the cover and disconnect the wires by pulling outwards. Push each side of the pin outwards until it releases. Then remove the headlight unit.
To remove the headlight unit on a Vectra C, start by opening the hood and disconnecting the battery for safety. Next, remove the screws or clips securing the headlight assembly, usually located at the top and sometimes on the side, depending on the model. Gently pull the headlight unit forward to detach it from the mounting points, and disconnect the wiring harness. Be cautious not to damage any surrounding components during the removal.
there is a pin on the switch which must be depressed to remove the unit from the dash.
how do you remove the ecu unit from a vauxhall astra 1.4 sl
you first have to remove the upper and lower plastic covers from the steering column.then you can remove the control stalk as a unit .it contains the headlight switchand cruise control switch in one unit . just remove the screws and disconnect the electrical connector . this piece is just over 100 dollars at the dealer or 60-65 dollars at the parts store. you
Remove backing plate on headlight unit.
There are two bolts holding the unit to the vehicle. Open the hood, look down on the headlight unit, and you will see the two bolt heads. Remove the two bolts, one will be long the other short. Then pull the headlight unit from the car. You will need to disconnect the the headlight wiring if you are benching the unit.
the flasher unit is built into the hazard light switch on dash you have to remove the small cover around switch unit & remove switch remove plug from back & replace whole unit
To remove the headlight unit on an Alfa Romeo 147, first, open the hood and locate the retaining screws or bolts securing the headlight assembly. Remove these screws using the appropriate tool, typically a Torx or socket wrench. Afterward, gently pull the headlight unit forward to disengage it from the clips, and disconnect the wiring harness at the back of the unit. Finally, lift the headlight assembly out of the housing for replacement or maintenance.
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.
Open the hood of the engine compartment. Remove the wiring harness from the headlight. Remove the retaining bolts from the headlight assembly. The headlight unit will come out. Reverse the process to install the new headlight.
To remove the headlight on the mx-3 you must unbolt the front bumper, loosen all 4? bolts and disconnect the headlight wiring. The whole unit should just pull right off.