it is located behind the coil packs
where is the ignition control module loacted on a 1997 chevy cavalier
Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.
It depends on what engine yu have but on a lot of them it is under the coils. If your car has a dist it is inside.
under the coil packs and the coil packs are connected to the spark plug wires
IF IT IS A 4 CYL YOU PROBABLY HAVE A BAD CRANK SENSOR OR IGNITION MODULE.
Its attached to the windshield wiper motor you will have to remove the cowl to get access to it.
Behind the coil pack in the front lower center part of the engine.
On the V6 the ignition module is under the distributor cap.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder