Type your answer here... the easyest but not to safe way to get an o2 sensor out,is to get the engine under normal working temp. then switch off the engine and proceed to remove it NOTE:BECAREFUL NOT TO GET BURN AND USE A 6 POINT LINE SPANNER.
How many oxygen sensor on your 1999 3.5 rl?
The air flow sensors are located on the intake tract between the air filter and the throttle body.
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
Visit this website and look at picture of MAP sensor on 1999 Hyundai Accent, http://www.rockauto.com/catalog/raframecatalog.php?carcode=1355688&parttype=5124&a=FRc1355688k1262718
The oxygen sensor on a 1999 Honda Civic is located on top of the catalytic converter. The catalytic converter is under the car.
The oxygen sensor is located in the exhaust manifold near the firewall. It is easier to get to the sensor from under the vehicle.
It depends on which of the. Camry 1999 LE has two of them. One is next to the engine, another one is under the passenger seat. You get in AutoZone a special oxygen sensor wrench, I highly recommend to use because it's to brake the sensor. While the engine is still warm, disconnect the battery, disconnect the oxygen sendor from the wire harness. Remove the sensor using the wrench, be careful it can be hot. Install a new sensor, thighten it, connect to the harness. If you need to replace the sensor under the passenger seat, you will have remove the seat, if you want to disconnect it. Juck your car up. After that remove the sensor (you can find it in the exhaust pipe just under the passenger seat) using the wrench, install a new one, tighten it, connect the sensor to the harnees. Connect the battery.
No.
When the oxygen sensor goes bad, the check engine light goes on.
The oxygen sensors are in the exhaust pipes on most models.
That would be the O2 sensor after the catalytic converter.